Page 1 of 1

IS300 Clutch Master Cylinder

Posted: Thu May 18, 2017 6:22 am
by stabby
Would anyone know if the is300 clutch master would fit in place of an altezza clutch master cylinder?
Mine is leaking and thought it would be better to just replace it with the is300 version since that is more readily available than the altezza version.
From the looks of it it would fit where the two bolts need to be screwed in. The only changing that would be needed would be the line that leads the fluid to the clutch slave cylinder. That won't be a problem since a stainless steel one can be made from the master going to the slave.

So any thoughts on this? yay or nay? :)

Re: IS300 Clutch Master Cylinder

Posted: Wed Jun 07, 2017 12:12 pm
by RS Tom-Hundred
Not sure on this one myself but it would be useful to know, as it is for any parts that are or aren't interchangeable between the IS200/300 and the RS200 :)