ImageGreetings! Welcome to Tezzaworld website, unfortunately you are a few years late to the show as nearly everyone has been and gone, there is still lots of useful archived material to read through, not many active users unfortunately, but that’s the way it goes, hopefully you are not too disappointed...

high rev stroker

Post info/questions on engine mods and issues here
Trc On!
Posts: 59
Joined: Sun Apr 26, 2015 2:25 pm

high rev stroker

Postby oaasport » Wed Jun 14, 2017 11:48 pm

Since our cousin 3sgte motors have high rev capabilities, why can't it be done to an altezza that has a better flowing head? I have seen 9500 rpm out of a 3SGTE 2.3 stroker. That's a 1.45:1 rod ratio, 272 cams with 11mm lift, obviously it's a built engine lol. But I have never seen an altezza engine with a stroker turn over 7800 and every forum I have lurked said the same. But why? Is it rod ratio? (I call BS, it physically can spin it) nobody wants to take a chance to go boom? Is it because the engine won't last (again BS, 2.3 mr2 again with 35000 miles on build and over 100 passes at strip). Or is it because nobody has a trans that can take a boosted 9500rpm stroker beams?( This is probably​ the biggest reason lol) I would like to get some opinions before I start a build. My goal is a 2.26 liter blacktop beams 3sge with a gt3076 turbo, custom vvti cams with the head ports smoothed, Glenn's springs and retainers and a 9000rpm redline.

Return to “Engine & Transmission section”

Who is online

Users browsing this forum: No registered users and 1 guest