ImageGreetings! Welcome to Tezzaworld website, unfortunately you are a few years late to the show as nearly everyone has been and gone, there is still lots of useful archived material to read through, not many active users unfortunately, but that’s the way it goes, hopefully you are not too disappointed...

IS300 Clutch Master Cylinder

Post info/questions on engine mods and issues here
User avatar
Trc On!
Posts: 32
Joined: Wed Jun 20, 2012 2:37 pm
Location: Curacao

IS300 Clutch Master Cylinder

Postby stabby » Thu May 18, 2017 6:22 am

Would anyone know if the is300 clutch master would fit in place of an altezza clutch master cylinder?
Mine is leaking and thought it would be better to just replace it with the is300 version since that is more readily available than the altezza version.
From the looks of it it would fit where the two bolts need to be screwed in. The only changing that would be needed would be the line that leads the fluid to the clutch slave cylinder. That won't be a problem since a stainless steel one can be made from the master going to the slave.

So any thoughts on this? yay or nay? :)
1999 Altezza RS200-Z

User avatar
RS Tom-Hundred
Tezza Fanatic!
Posts: 480
Joined: Fri Nov 28, 2014 3:31 pm
Location: Cambridgeshire

Re: IS300 Clutch Master Cylinder

Postby RS Tom-Hundred » Wed Jun 07, 2017 12:12 pm

Not sure on this one myself but it would be useful to know, as it is for any parts that are or aren't interchangeable between the IS200/300 and the RS200 :)

Return to “Engine & Transmission section”

Who is online

Users browsing this forum: No registered users and 1 guest